Sauna Springbrunnen

Gentle splash, constant scent - with this small Springbrunnen you create (without any electricity) a relaxing atmosphere in the sauna. It comes, how could it be otherwise, from the land of sauna-goers, where it is made by hand from soapstone. Thanks to the heat-retaining material, it works on the basis of sauna heat alone: the soapstone transfers the absorbed heat to the water, which evaporates and constantly humidifies the air. Traditionally, the Springbrunnen is filled with water only; by adding fragrant sauna additives or essential oil, their fine aroma is distributed in the sauna with the steam.
The gentle splashing of the small water fountains is particularly soothing. These are created when some of the water in the tubes heats up to boiling point, whereupon it suddenly evaporates and is expelled. Due to the resulting negative pressure in the tube, water is sucked in again, heated, ejected ... With the first water filling, the Sauna-Springbrunnen bubbles softly at first. When you add water, powerful bubbling columns formbrunnen. During this initial phase, the Springbrunnen bubbles the most (therefore, be especially careful when filling the Brunnenbasin for the first time). With each refill, the bubbling becomes more consistent. However, you can also influence the Springbrunneneffect by its position at the heat source, the hotter the Brunnen is, the more the water bubbles.

Never try to change the position of the Springbrunnens while the furnace is hot.
Be extra careful when filling for the first time!
Do not let children play with the Brunnen unsupervised!

Preheat the sauna heater-Springbrunnen. After the sauna heater-Springbrunnen is placed on the sauna heater for the first time, properly heat the heater and keep it warm for at least one hour. Do not fill the Springbrunnen with water and do not pour water on the sauna heater!
Allow the sauna heater and Springbrunnen to cool down. Then the Springbrunnen can be used normally according to the instructions for use.